qmk_firmware/keyboards/matrix/falcon
Ryan 4ae9bfd17a
Move RGBLIGHT_HUE/SAT/VAL_STEP to data driven (#21292)
Co-authored-by: Nick Brassel <nick@tzarc.org>
2023-06-24 17:37:54 +10:00
..
keymaps Remove legacy keycodes, part 5 (#18710) 2022-10-15 22:29:43 +01:00
config.h Move RGBLIGHT_HUE/SAT/VAL_STEP to data driven (#21292) 2023-06-24 17:37:54 +10:00
falcon.c Move remaining LAYOUT_alls to data driven (#20463) 2023-04-27 07:45:43 +10:00
info.json Move RGBLIGHT_HUE/SAT/VAL_STEP to data driven (#21292) 2023-06-24 17:37:54 +10:00
readme.md RESET -> QK_BOOT keyboard readme (#18110) 2022-08-20 11:34:17 +01:00
rules.mk Migrate MCU and BOOTLOADER to data-driven (#19529) 2023-02-08 18:41:46 +11:00

Falcon AVR

PCB using atmega32u4 for the Matrix Falcon

  • Keyboard Maintainer: astro
  • Hardware Supported: Matrix Falcon
  • Hardware Availability: Limited GB

Make example for this keyboard (after setting up your build environment):

make matrix/falcon:default

Flashing example for this keyboard:

make matrix/falcon:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard.
  • Physical reset button: Briefly short cut the RST pin with the GND pin (pin at the topside of the RST) on the back of the PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.