qmk_firmware/keyboards/crin
2021-12-09 16:05:44 +11:00
..
keymaps Crin Refactor (#13982) 2021-08-13 17:01:05 -07:00
config.h [Keyboard] Added Crin keyboard (#13630) 2021-07-22 18:47:32 -07:00
crin.c [Keyboard] Added Crin keyboard (#13630) 2021-07-22 18:47:32 -07:00
crin.h Crin Refactor (#13982) 2021-08-13 17:01:05 -07:00
info.json Remove width, height and key_count from info.json (#14274) 2021-09-12 14:04:56 +10:00
readme.md Crin Refactor (#13982) 2021-08-13 17:01:05 -07:00
rules.mk Tidy up NKRO_ENABLE rules (#15382) 2021-12-09 16:05:44 +11:00

Bachoo Crin

Crin is an F-rowless 65%.

  • Keyboard Maintainer: KnoblesseOblige
  • Hardware Supported: STM32F303CBT
  • Hardware Availability: TBD

Make example for this keyboard (after setting up your build environment):

make crin:default

Flashing example for this keyboard:

make crin:default:flash

To reset the board into bootloader mode, do one of the following:

  • Hold Esc while plugging the PCB in, if Bootmagic Lite is enabled (also erases persistent settings).
  • Press the RESET keycode, if programmed on the keymap (Fn+R by default).
  • Slide the switch just below the reset button to the left and press the reset button.
    • Please note that you must slide it back to the right for the PCB to boot QMK again.

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.