qmk_firmware/keyboards/4pplet/eagle_viper_rep/rev_a
2023-07-08 23:13:10 +10:00
..
keymaps Adding Duck Viper/Eagle V2/V3 Replacement PCB Rev B (#18584) 2022-12-19 20:59:48 +11:00
chconf.h Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2021-06-22 08:09:16 +10:00
config.h Relocate backlight drivers (#21444) 2023-07-08 23:13:10 +10:00
halconf.h Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2021-06-22 08:09:16 +10:00
info.json Move RGBLIGHT_HUE/SAT/VAL_STEP to data driven (#21292) 2023-06-24 17:37:54 +10:00
matrix_diagram.md 4pplet/eagle_viper_rep/rev_a Layout Macro Conversion and Additions (#20414) 2023-04-12 14:29:29 -07:00
mcuconf.h Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2021-06-22 08:09:16 +10:00
readme.md Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2021-06-22 08:09:16 +10:00
rev_a.c Adding "Eagle Viper Rep", open sourced Eagle/Viper V2/V3 PCB (#13020) 2021-06-22 08:09:16 +10:00
rev_a.h 4pplet/eagle_viper_rep/rev_a Layout Macro Conversion and Additions (#20414) 2023-04-12 14:29:29 -07:00
rules.mk Remove CORTEX_ENABLE_WFI_IDLE from keyboards. (#21353) 2023-06-23 20:31:25 +01:00

Viper/Eagle REP Rev A

A alternative PCB for Viper and Eagle V2 and V3

  • Keyboard Maintainer: 4pplet
  • Hardware Supported: Viper/Eagle REP Rev A

Make example for this keyboard (after setting up your build environment):

make 4pplet/eagle_viper_rep/rev_a:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

  • Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
  • Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.

Alternative option if the firmware is already pre-flashed:

  • Unplug your keyboard, hold down the Spacebar and B at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.