Split the toolchain setup into separate docker and native pages
and improve instructions to better refer to Zephyr docs in certain steps.
Also refactor to improve consistency and add virtualenv instructions.
---------
Co-authored-by: KemoNine <mcrosson@kemonine.info>
Co-authored-by: Cem Aksoylar <caksoylar@users.noreply.github.com>
* Use the correct property for extra GPIOs to
make active for the waker before going into soft
off state.
* Change header depth for easier navigation of the
soft off feature page.
Co-authored-by: Pablo Martínez <58857054+elpekenin@users.noreply.github.com>
* Better naming for gpio-key behavior triggers.
* Tweaks to scanned behavior trigger to avoid bad semaphore use,
and reduce chance of issues with slowly scanned matrixes.
* Various code cleanups of style issues.
* Move to explicit enable of `ZMK_PM_SOFT_OFF` to turn
on the feature and use the behaviors, which matches
how other features work, and helps with split and
testing schemes.
Initial work on a soft on/off support for ZMK. Triggering soft off
puts the device into deep sleep with only a specific GPIO pin
configured to wake the device, avoiding waking from other key
presses in the matrix like the normal deep sleep.
Co-authored-by: Cem Aksoylar <caksoylar@users.noreply.github.com>
Updated the section for troubleshooting split halves unable to pair now
that the settings_reset shield resets all settings and explicitly
disables CONFIG_ZMK_BLE:
- Added a note that all settings will be reset.
- Removed the section about immediately putting the halves into
bootloader mode to prevent pairing, as this is not necessary anymore.
- Added a note that you will not be able to see or pair the Bluetooth
keyboard until you have flashed regular firmware again.
- Added a sentence to clarify that you will need to re-pair the
keyboard to all host devices.
Also added some text describing common scenarios where this procedure
might be needed.
Added a new CONFIG_ZMK_SETTINGS_RESET_ON_START option which enables init
code to call zmk_settings_erase(), and changed the settings_reset shield
to use it instead of CONFIG_ZMK_BLE_CLEAR_BONDS_ON_START, so it now
resets all settings instead of just clearing BLE bonds.
CONFIG_ZMK_BLE_CLEAR_BONDS_ON_START is left in place for now in case
someone still needs it. It may be replaced in the future once we find a
better way to repair a broken split connection.
Added a warning to the shield section explaining that Kconfig does
not ignore whitespaces on function calls and therefore adding whitespaces
after the comma will break functionality.
Added an upgrade function to the keymap upgrader to replace the encoder
"resolution" property with "steps" and (if it is not already present)
"triggers-per-rotation".
Fixed an issue where a text edit at the very end of a file would cause
it to highlight from the start of the edit to the start of the file
instead of to the end of the file.
