Added a Kconfig option to enable SOC_DCDC_NRF52X_HV for nice_nano_v2
and mikoto. According to Nordic's documentation, the DC/DC regulator is
more efficient than the LDO regulator, so this is enabled by default.
The following boards do not support this mode and were not changed:
- nice_nano
- nice60
- nrfmicro_11, nrfmicro_13
- nrf52840_m2
- bluemicro840
I could not find schematics to confirm whether the following boards
support this mode:
- bt60_v1, bt60_v2
- bt65_v1
- bt75_v1
- corneish_zen_v1, corneish_zen_v2
- pillbug
- puchi_ble_v1
- s40nc
The devicetree pulls always add on to the extra pulls configured by toggle mode, so these should not have pulls defined in the devicetree. Saved ~200uA avg on another board with a 3t toggle switch
* In order to be sure the rest of the system is fully ready before
intializing, because init may result in immediate events being
triggered when used with toggle direct kscan inner devices.
* Add dedicated init priority for the sideband kscan.
* Refactor sideband code for clarity.
* Tweaks to direct kscan for clarity.
* Make sideband behavior row optional for brevity.
* Allow overriding ZMK Uno sideband behaviors.
* Instead of gpio key behavior trigger, add new kscan driver that
decorates/wraps a given kscan driver and will invoke basic system
behavior assigned to a given row + column, without the need for keymap
mapping in the matrix transform, bypassing keymaps entirely.
* Better naming for gpio-key behavior triggers.
* Tweaks to scanned behavior trigger to avoid bad semaphore use,
and reduce chance of issues with slowly scanned matrixes.
* Various code cleanups of style issues.
* Move to explicit enable of `ZMK_PM_SOFT_OFF` to turn
on the feature and use the behaviors, which matches
how other features work, and helps with split and
testing schemes.
Initial work on a soft on/off support for ZMK. Triggering soft off
puts the device into deep sleep with only a specific GPIO pin
configured to wake the device, avoiding waking from other key
presses in the matrix like the normal deep sleep.
Co-authored-by: Cem Aksoylar <caksoylar@users.noreply.github.com>
* To be able to use the Zephyr `voltage-divider` driver,
add a mode for fetching raw voltage from the sensor
and do state of charge calculation outside of the driver.
* Add a dedicated settings reset on start init priority and default
it to lower priority (high number) than default FLASH_INIT_PRIORITY
to be sure flash is initialized before we open the area.
