39 lines
2.1 KiB
Markdown
39 lines
2.1 KiB
Markdown
# Adafruit MacroPad RP2040
|
|
|
|
|
|
|
|
A RP2040-powered Macropad with a 3x4 layout.
|
|
|
|
- Keyboard Maintainer: [Jpe230](https://github.com/jpe230/)
|
|
- Hardware Supported: Adafruit MacroPad RP2040
|
|
- Hardware Availability: [Barebones kit](https://www.adafruit.com/product/5100) [Starter Kit](https://www.adafruit.com/product/5128)
|
|
|
|
Make example for this board (after setting up your build environment):
|
|
|
|
```sh
|
|
qmk compile -kb adafruit/macropad -km default
|
|
```
|
|
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
|
|
|
## Features
|
|
|
|
- Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
|
|
- 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
|
|
- One NeoPixel RGB LED per switch, on north side.
|
|
- Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
|
|
- 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
|
|
- 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
|
|
- STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
|
|
- Reset button - On the side, for quick restarting, press it twice to enter bootloader.
|
|
- Four M3 mounting bosses - Make custom enclosures easily.
|
|
|
|
## Bootloader
|
|
|
|
Enter the bootloader in 4 ways:
|
|
|
|
* **Bootmagic reset**: Hold down the key just below the rotary encoder push-button on power-up.
|
|
* **Physical reset button**: Press twice the button on the side while the board is connected.
|
|
* **BOOT button** Hold down the rotary encoder push-button on power-up or reset.
|
|
* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available.
|